Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a bit but it's still appealing. It's not the plushest car in its class and an Ford Focus or Volkswagen Golf will shield you from imperfections on the road - however, it's a comfortable and civilised driving experience.
We get asked frequently at Coded Car Keys to replace
peugeot key fobs. The following tips can help whether the problem is ongoing or intermittent.
Water Damage
If you leave your key fob in a puddle or get it wet when kayaking, swimming, canoeing, rafting or canyoning, it's probably to suffer water damage. The best way to prevent this from happening is to always keep it in a dry bag when you're outside or performing activities that require the fob to be exposed to a lot of water.
You'll also want to make sure that the fob is dry before opening it up and using it again. If you notice any odors emanating from the fob like an industrial smell or a sour taste like windshield washer fluid, it's another indication that it's been submerged in water.
A circuit board that is wet could cause the battery to discharge its charge or even explode. If you can remove the 308 keyfob from the water it is best to turn the button side up and shake as much water out as possible before opening the casing. When you've opened it, take off the battery, and then clean the circuit board using the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote entry keyless system might not work include a dead battery in the coin-cell, receiver module problems signal interference, or a defective chip. If none of the above is the cause you can reset the system by removing the 12 volt battery from your car for 15 mins.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system which allows the driver to start the car from afar and then warm up or cool down the vehicle prior to entering. This feature is extremely beneficial particularly during the winter's cold and chilly months. However, there are times when the remote start system stops operating due to a range of causes, such as an unresponsive coin battery.
The coin-shaped battery located inside the key fob will last between two and four years depending on the frequency with which it is used, where it was purchased, and how it is used. The date of use will be written on the packaging or marked in the user manual.
If the key fob stops working after exposure to clean tap water and you want to take the battery off, clean the electronic chip using a paper towel and isopropyl ethanol, then dry it completely before replacing it. If the key fob has been exposed to soapy or salty water, it may have caused the chip to become damaged. It is recommended to replace it.
If you're not sure whether the battery is defective You can test its voltage with a multimeter attached to both the terminals plus and minus. If the voltage is less than 12-13 volts then you need to replace the battery. You can also reset your computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should be able to start after this.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, it's possible that your receiver module has created a fault. It's the component that transmits an alert when the key fob goes off. It also functions as an alarm and prevents the vehicle from starting without the correct key.
It could be due to several causes, such as water damage or simply ageing. If the electronic chip within your Peugeot 308 keyfob has been damaged by dirty tap water, it could be because the keyfob was exposed it. In this situation, you'll have to remove it and clean it thoroughly using isopropyl or electronic cleaner. Once the battery is dry then you can try again.
If the issue isn't resolved you're probably in need of a idea to visit an area Peugeot specialist or locksmith. They'll be able to make use of a diagnostic device to assist in identifying the problem and fix it.
It is stressful to lose your Peugeot car key. However, a qualified auto locksmith can resolve the issue in only a few minutes. They can cut a new key and then program it into your vehicle, ensuring you're ready to get off the road as quickly as possible. Click here to find the nearest locksmith.
Electronic chip malfunctions
The chip in the Peugeot 308 key fob plays a crucial role in the remote control system. If it is damaged your car may not start or you may receive a message stating "anti-theft active". In this case the only option is to replace the key. Luckily, professional auto locksmiths can provide the service in the shortest time.
The chip in the key fob of your Peugeot 308 may fail due to a variety of reasons, including sweat, water damage, or dirt. If your
Peugeot key fob has been exposed to soapy or dirty water, it should be cleaned as soon as possible. You can employ a paper towel as well as isopropyl alcohol to clean the electronic component. The battery must then be allowed to fully dry.
Sometimes the key fob may cease to function due to radio interference. This could be due to other devices use the same frequency as your Peugeot keyfob. This could be due to poor conditions or objects close to the vehicle. If you experience this issue, it is best to visit a
peugeot key replacement dealership.
The Peugeot 207/308 Key Fob is fragile and requires special attention. It should not be dropped or throw it around. If you lose something, try to locate it as soon as you can. You can reset all the on-board computers by disconnecting the 12 volt battery for a short period of time. Remove the negative cable before the positive.